![]() ![]() ![]() The E3 is working more consistently - often doesn't connect automatically but then will connect when I manually click Connect. After upgrade, and doing a forced re-install on both, connectivity is "spotty" at best. Used to have rock-solid connectivity from Octoprint to my Ender 3 Pro and my Ender 5 Plus (both separate OP installs on separate Pi devices). Issue persistent / noticeable on Safari, Chrome, and FireFox Running also on network a Linux server with SpaghettiDetective and OctoFarm OctoPrint version, OctoPi version, printer, firmware, browser, operating system. Logs.zip (226.3 KB) Additional information about your setup Updating the Rasbian OS (apt-get update etc) Complete Logs Going to a known good backup for this setup - after restored backup the Octoprint version was still 1.4.2 ![]() Trying the FAQ forum advice(s) for a frozen Octoprint page Remove the plugin that also updated recently This issue is occurring on my Creality Ender 3, Flashforge Creator Pro, and Filament Innovations BFP310 all since I upgraded them at once. Furthermore - I've always used Simplif圓d and a Curl script to auto upload and start new prints and after the update when doing this is shuts down Octoprint until I SSH in and reboot it. The web stream worked fine and I could go through settings and download logs and remove plugins but only through the IOS app could I connect serially and move the printer axes. After updating Octoprint the Octoprint webpage would be stuck connected to print and would not allow me to disconnect even if the printer was shut off. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |